Accessories

For use with Sigfox/LoRa/External WiFi Antenna sold on this site. Includes Nut, washer and rubber ring. Ideal for use with IP67 cases.

External WiFi and antenna cable (non-IP67). Includes antenna, cable, washer and nut.

External LTE-M Antenna Kit for use with the FiPy and GPy development boards.

PyCase can hold either LoPy, WiPy, FiPy, SiPy or GPy with an expansion board and attached antenna.

External LoRa and Sigfox antenna. Can be used with either the LoPy4, SiPy or FiPy.

Meet our new Pygate case. It will fit your Pygate in perfectly. It’s a translucent smokey colour, made from a polycarbonate material. Pygate is an 8-channel LoRaWAN gateway. Connect your WiPy 3.0, LoPy4 and GPy and hook up any other Pycom devices and voila – a decentralized IoT network.

NOTE:
* Please note purchasing the case does not include Pygate or the antenna connectors displayed on the photo.

External LTE-M Antenna Kit for use with the FiPy and GPy development boards.

External GPS/Glonass antenna and cable. Includes antenna, cable assembly with nut and magnet (with base sticker) to attach GPS antenna to external metal surfaces.

This GPS antenna has been optimised to work with the NEW Pytrack 2.0 X shield.

Pytrack 2.0 X shield is NOT included

The Universal IP67 Case is Pycom’s very own universal waterproof case, with push-in tabs that fit accessory sensors perfectly, creating a water tight seal. Two holes go straight through the case without penetrating the inner compartment, meaning you can fix the case securely in place.

The case features perfectly sized spacing for a Pycom expansion board or sensor shield, a Pycom module and battery, plus sensors.
Please note that whilst the IP67 case has pre-cut holes (which are water resistant until you pop these out), you may need to use some sealant should you drill out the hole and make the case watertight.